PRODUCT

12mm 12V 90leds RGB WWA LED Strip

Features

1- Addressable RGB or WWA Pixel LED Strip

2- External chip WS2818, the LED Type is SMD5050 WWA  or SMD5050 RGB

3- 96LEDs per meter, 32pcs WS2818 ICs per meter

4- Each 3leds as one group can be uct, the cut line every 3.125mm;

5- 4Pin JST SM connector on both end for signal transfer and extra two wires for power feeding. 

6- Black / white PCB for optional

7- Waterproof grade:

  • non-waterproof IP20
  • waterproof with silicon tube casing IP65
  • waterproof IP67 is with neon housing
  • waterproof IP68 is injection glue & silicone tube

8- Controller : SD card controller , Artnet , Ardunio and so on.

 

    

P/N: SJ-10096-2818-WWA-12V-12MM

12mm width Digital LED flexible strips
- SMD 5050 WWA LED
- 96 pcs LEDs /m, 32pcs WS2818 ICs/m
- DC12V , 23W/M
-5m/roll 
- white/black PCB (3OZ)
- Non-waterproof

 

P/N: SJ-10096-2818-12V-12MM

12mm width Digital LED flexible strips
- SMD 5050 RGB LED
- 96 pcs LEDs /m, 32pcs WS2818 ICs/m
- DC12V , 23W/M
-5m/roll 
- white/black PCB (3OZ)
- Non-waterproof

Details & Description

PCB& Copper

1. The normal PCB width is 12mm, also could be customized;
2. The normal cooper thickness is 3oz (1oz front& 2oz back)

Connector Option

1. The normal is 4pin JST SM male& female, and 15cm wire length
2. The connector & wire length could be customized

WS2818 chip

1. The R, G, and B output ports have a voltage resistance of 12V, and the DIN port has a voltage resistance of 9V.
2. The chip has a built-in voltage regulator. For power supplies of 12V and below, you only need to connect a resistor to the VDD pin of the IC, without the need for an external voltage regulator.
3. Built-in signal shaping circuit, any pixel receives the signal and then outputs it after waveform shaping, ensuring that line waveform distortion will not accumulate.
4. Built-in power-on reset and power-off reset circuit.
5. The PWM control terminal can realize 256 levels of adjustment and the scanning frequency is 2KHz.
6. Serial cascade interface can complete data reception and decoding through a signal line.
7. Resume downloading at breakpoints. Even if a single chip is damaged, the overall display effect will not be affected.
8. When the transmission distance between any two points does not exceed 5 meters, there is no need to add any circuits.
9. The color of the light is highly consistent and cost-effective.
10. When the refresh rate is 30 frames/second, the number of cascades is not less than 1024 points.
11. Data transmission speed can reach 800Kbps.

Read more!